MicoAir PlaneIO Board for Airplanes

In Stock
€ 9,79

MicoAir PlaneIO Board is an adapter board that allows MicoAir flight controllers to be used in airplanes and flying wings. It combines power distribution for ESCs and a pin header for connecting servos in a single unit, giving a flight controller originally designed for multirotors a typical fixed-wing layout.

The board features a pin header with 10 outputs, each with three pins (signal, positive and negative), for direct connection of servos and ESCs using standard servo connectors. Both straight and angled headers are included, allowing them to be routed upwards or to the side depending on the available space in the fuselage. The board connects to the flight controller via two SH1.0 8pin cables, so there is no need to solder signal wires directly to the flight controller.

The power section consists of large solder pads for the battery input and pads on the sides for ESC power wires. The package includes an XT60 connector, 12AWG power wires and a Low-ESR capacitor, which is soldered to the power input to suppress voltage spikes.

The board has a 30x30mm M3 mounting pattern, measures 36x50mm, is 4.8mm high and weighs only 5g. It is mounted underneath the flight controller: M3 screws are inserted through the board from below and secured with nuts, the flight controller's anti-vibration standoffs are fitted onto them, and the entire stack is screwed to the base plate.

Key Features

  • Type: Adapter IO board for airplanes
  • Compatibility: MicoAir flight controllers
  • Servo outputs: 10x (signal, positive, negative)
  • Flight controller connection: 2x SH1.0 8pin
  • Mounting holes: 30x30mm M3
  • Size: 36x50x4.8mm
  • Weight: 5g

Package Includes

  • 1x PlaneIO board
  • 2x SH1.0 8pin 3cm connection cable
  • 1x Low-ESR capacitor
  • 1x XT60 connector
  • 3x 10pin straight pin header
  • 1x 10pin angled pin header
  • 1x 12AWG red power wire
  • 1x 12AWG black power wire
  • 8x M3 nut
  • 4x M3x16mm screw