Bison Spray Adhesive

Contact spray adhesive based on SBR rubber designed for gluing larger surfaces of a variety of materials. The adhesive is resistant to temperatures from -40 °C to +50 °C. It can bond paper, cardboard, wood, fabric, leather, metal, felt, foam polystyrene (Styrofoam), and other foam materials, various plastics with the same and different materials. Not suitable for PE and PP. The adhesive is primarily suitable for covering RC model aircraft with film.

Shake the container well before use, spray the adhesive from a distance of about 15–25 cm. Contact bonding: Spray the surfaces to be bonded on both sides and allow to dry for 10 minutes. Then press both parts together firmly for a short time. Bonding with correction: For bonded surfaces where at least one is porous (absorbent), the adhesive can be applied to only one bonded surface and the materials joined immediately. Corrections are possible for 5 minutes. The drying time is approximately 24 hours. Repositionable bonding: Spray the adhesive on one surface and let it dry for 20 minutes. A continuously sticky layer will be created, allowing repeated sticking and peeling of the material.

After use, hold the container upside down and spray any remaining adhesive from the nozzle until only propellant gas comes out of the spray valve.

SAFETY WARNING

Labeling according to Regulation (EC) No. 1272/2008 (CLP). The product contains substances classified as hazardous under Regulation (EC) No. 1272/2008.

GHS02 - Flammable substances GHS07 - Irritating substances GHS09 - Substances hazardous to the environment

Signal word: DANGER

H222 - Extremely flammable gas.
H229 - Pressurized container: may burst if heated.
H315 - Causes skin irritation.
H336 - May cause drowsiness or dizziness.
H411 - Toxic to aquatic life with long-lasting effects.
P101 - If medical advice is needed, have product container or label at hand.
P102 - Keep out of reach of children.
P210 - Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. No smoking.
P211 - Do not spray into an open flame or other ignition source.
P251 - Do not pierce or burn, even after use.
P261 - Avoid breathing vapors.
P410+P412 - Protect from sunlight. Do not expose to temperatures exceeding 50 °C.
P501 - Dispose of contents/container according to national regulations.
P271 - Use only outdoors or in well-ventilated areas.

Hazardous substances content: Hydrocarbons C6–C7, isoalkanes, cyclic.

Always follow the information on the product label. Safety data sheet here.