Due to preparations for the Inovujeme Plzeň race, it will be possible to pick up personal collections only until 1 pm on Friday 2 June 2023. Shipments will be sent in the standard way. 

Diatone Mamba MK4 F722 Wing

In Stock
€ 71,60

Flight controller is designed for classic airplanes and monoplanes. Compared to standard copter flight controllers, the Mamba Wing has better output pin layout and an integrated PDB. Connecting the flight controller to the aircraft is thus noticeably easier. You either feed the servos to the output pads, or you use the pin bar and classic servo connectors. The integrated PDB will facilitate the distribution of the supply voltage and the connection of the regulators. The controller is equipped with connectors for connecting DJI FPV and external USB. In this way, you place the USB connector in an accessible place. The flight controller is suitable after use with the iNav firmware.

The F722 Wing has mounting holes with a pitch of 20x20mm. It can be attached to the screws or glued to the hull with the help of the bottom plate. The board can switch the output voltage for the video transmitter. It can therefore be easily switched off using the RC radio and thus prevent unwanted overheating, for example when waiting for GPS satellites. The controller has a 5V 3A BEC to power the servos. If you will be using more than 2-3 5g servos, it is advisable to use an external BEC.

Key Features

  • MCU: 216MHz STM32F722
  • IMU: ICM-42688-P
  • INAV Target: MAMBA F722_WING
  • Support OSD
  • Blackbox: 16MB
  • Barometer: SPL06
  • Number of UARTs: 8
  • Support I2C
  • Number of motors/servos outputs: 8
  • Connector for external USB
  • Input Voltage: 3-6S
  • PDB Current: 40A
  • Current senzor
  • BEC: 3,3V@0.5A, 5V@3A, 9V@2A
  • Mounting hole: 20x20mm M2

Package Includes

  • 1x Flight controller
  • 1x External USB
  • 1x sets of Cables
  • 1x sets of pins